Elmo CRC-1 Bedienungsanleitung PDF herunterladen (Seite 17)

4. Model window description

When [Model] is selected from the menu, a new window opens.

Here you can edit the projector command tables.

Check and set the baud rate, parity bit, data bits and stop bits of the projector that you want

to use.

Check each command and enter them in Codes as HEX codes.

After finishing the entries, select [Save] or [Save As] to save.

The saved model file is used in the Project.

■Delay On and Delay Off

Do not change this setting.

■RS232 Settings

Speed is the setting for the baud rate, Parity is for the parity bit, # of data bits is for the data

bits, and # of stop bits is for the stop bits. Set as appropriate for the projector.

■Codes

Enter projector commands that are suitable for each item. Use single byte alphanumerics for the

input, and enter them from the left.

If a single command in the ON/OFF format is not used for the Sync_ON and Sync_OFF inputs,

Because the same commands as Computer are used for Document Camera, do not enter anything

for Document Camera. Even if a command is entered, the unit will not be updated with it.

No. Button Description

(1) [Model]

Displays a list of the existing model files. Select the model that

you want to download. The selected model name is displayed on

the button.

(2) [New] Creates a new model.

(3) [Save] Saves by overwriting the model file that you are currently editing.

(4) [Save As]

Saves the model file that you are currently editing with a different

name.

(5) [Delete] Selects and deletes an existing model file.

(6) [Exit] Closes the Model window.

(7) [Clear] Initializes Codes.

(1)

(2)

(3)

(4)

(5)

(6)

(7)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 26 27

Keine Kommentare

Elmo CRC-1 Bedienungsanleitung Seite 17