CRC-1 Installation Manual
10 Using the programming tool Requirements for the Computer on which the programming tool is to be installed OS: Windows 2000/XP or later At lea
11 "ELMO RS232 Programming Ver1.0" is displayed in the main window. [Project], [Model], [Settings], [About] and [Quit] are available in t
12 Select [Project] from the menu of the programming tool. The Project window opens. Register the model of your projector and save it as a project
13 While pressing and holding the unit's (Volume Down) button and (MUTE) button (3 seconds), insert the AC Adapter. When the buttons are
14 Caution If you download an edited project to the unit before you save it, the unit will not be updated with the edited information. Disconn
15 3. Project window description When [Project] is selected from the menu, a new window opens. Here you can edit the models that you will use in a p
16 To create a new project, press [New]. Enter a file name, and then select and save the model files. The file name is displayed in [Project Name].
17 4. Model window description When [Model] is selected from the menu, a new window opens. Here you can edit the projector command tables. Check and
18 To register a new command table, press [New]. A new window opens. Enter a file name and press the OK button. Check that the entered file name is
19 5. Settings window description When [Settings] is selected from the menu, a new window opens. Here you can perform the Com port settings. Sele
2 Contents 1. Usage Precautions ... 3 2.
20 5. Appendix Pin assignment 1. RGB (Dsub15 for video) Dsub15 (female) Pin No. Signal Pin No. Signal 1 Video signal (red) 9 N.C 2 Video
21 3. Details of supplied RS cable Dsub9 (male) Dsub9 (female) Control connector on CRC-1 side Control connector on projector side Pin
22 4. Details of supplied IR cable Dsub9 (male) Control connector on CRC-1 side Pin No. Signal 1 N.C 2 N.C
23 Programming cable 4P connector model number: XHP-4 (made by JST) Dsub9 (female) 4P connector Pin No. Signal Pin No. Signal 1 N.
24 Command tables This section shows the RS-232C commands that are registered in the unit and the commands in the supplied data. When changing th
25 3M BenQ BUTTON COMMAND BUTTON COMMAND Baud rate 19200 Baud rate 115200 ON 31113F ON 0D2A706F773D6F6E230D OFF 31113E OFF 0D2A706F773D6F6666
26 RS-232C connector These are the pin assignments for the recommended projectors. (As of February 2010, researched by ELMO) We have made every e
27 is a registered trademark of ELMO Co., Ltd. Company/product names described in this manual are trademarks or registered trademarks of their re
3 1. Usage Precautions Read "Instruction Manual.pdf" carefully before using this option. When using an output from the expansion boar
4 3. Installing the Expansion Board Disassembly view Remove the two screws under the front cover, and remove the rear cover so that the expa
5 Fix in advance to the installation location. Connect the expansion board by referring to "Connecting the connectors and expansion board&q
6 Connecting the connectors and expansion board The figure below shows the unit with the rear cover removed. Connect the colored connectors of th
7 Installation method The installation method for the expansion board is shown below. Diameter of installation hole on expansion board: Ф4.7 mm U
8 Cable connections The methods for connecting peripheral devices to the expansion board are described below. When connecting the cables, insert
9 4. About RS-232C Supported models This section shows the models that are supported by the commands registered in the unit, and the models t
Kommentare zu diesen Handbüchern